Thread Rating:
  • 300 Vote(s) - 2.84 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NR error code
#3
Hello Dave,

Thanks for the response. I powered down, re engaged but still the problem is there. Normally the display shows in stand by mode '- -' when it receives signal from fob it turns to 'Go' then briefly 'NR' appears and comes back to '- -' [This was the original problem]

I solved this now. May be someone else will find this posting useful.

I disengaged both the motors and engaged them. Closed fully manually, re engaged again (note my gates engaged only half way through) powered up.

:-)

Works again as it should.

Thanks for all your help here in the forum and in Proteco.

Regards
Bara
Reply


Messages In This Thread
NR error code - by Bara - 26-09-2013, 08:43 AM
RE: NR error code - by Blakey111 - 26-09-2013, 11:53 AM
RE: NR error code - by Bara - 26-09-2013, 04:43 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  TC fault code on Q60ar control board Skydive1710 3 5,033 20-11-2023, 03:12 PM
Last Post: NormanY
  Proteco Advantage (Q60A) Error Code "03" CLAUDIOTX 3 19,255 26-09-2023, 05:32 AM
Last Post: max666
  Q80A Fault Code kevcl15@yahoo.co.uk 1 2,837 03-02-2023, 12:00 PM
Last Post: SamA
  Proteco Q60 - FH error then close after opening Needlerp 1 3,087 24-06-2022, 09:54 AM
Last Post: JamieF
  Thalia P - BAR error devsolo 2 11,182 07-01-2021, 04:05 PM
Last Post: GilbertoMoncada
  Deimos BT 400/600 error codes orange 0 4,402 07-12-2020, 09:36 AM
Last Post: orange
  Fav sliding gate error code plus other Adam67 0 9,462 02-09-2020, 07:06 PM
Last Post: Adam67
  Re: Error 30 tony.jay8 2 12,005 10-05-2018, 11:17 PM
Last Post: tony.jay8
  DAITEM WIRELESS INTERCOM how do I change entry code?? Help! Scarlett 3 24,423 04-05-2018, 07:43 AM
Last Post: Gagobaa
  BFT Error 35 & 37 Not opening fully - SOLVED razer raz 4 42,667 14-11-2017, 04:02 PM
Last Post: razer raz

Forum Jump:


Users browsing this thread: 2 Guest(s)