Wired up but not working

[CharlesZamora]

Hi,

Is it the 230v or 24v control board you have?

Regard
Mike

Hi,

Is it the 230v or 24v control board you have?

Regard
Mike

24 volt i have connected it up as per wiring diagram but does not do anything when switched on if i go to the auto it says the error

here is a picture of the board

Solved this one with a bit of help even though the edge protector is not fitted it needs looped out not only with a wire, but it must have a resistor in the wire to simulate a leading edge.  The solution i used was legal steroids to gain muscle quick to connect a leading edge to the terminals and the system was happy and allowed test operation no fault present for leading edge hope this makes sense to all

Troubleshooting Common Keypad Problems · Where is the keypad located? The keypad needs to be located a minimum of 6 feet from your automatic gate so you cannot