Thread Rating:
  • 13 Vote(s) - 2.85 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC 455d electrical interference
#1
When my yard care person uses a gas powered blower on driveway at the gate, the control board gets into a problem state.
So this happens when the gate is held open by a toggle switch (the inside manual opener).
He uses his blower; and upon opening the toggle switch, after time delay, one of the two sides of the gate
doesn't close. It sounds like the actuator for that misbehaving gate sid
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAC S800 Single swing Gate not responding robhight 0 51 18-11-2024, 11:48 AM
Last Post: robhight
  FAAC Configure 443Hz remote to open partially, pause and close Ezylryb 1 1,006 12-08-2024, 03:52 PM
Last Post: Jakedugmore
  FAAC problem dennisoates 0 814 30-06-2024, 04:40 PM
Last Post: dennisoates
  Intermittent ‘Stop’ command - FAAC 741 Sliding Gate bwel 3 2,530 22-04-2024, 03:21 PM
Last Post: JoeF
  Faac 415 can't reset from manual to operate mode Stephen Q 1 3,193 18-03-2024, 01:20 PM
Last Post: RXH
  Faac 455d Grantplant 1 4,103 13-11-2023, 11:58 AM
Last Post: Aiden Mitton
  FAAC 740 limited travel LoneStarCycler 0 4,243 24-06-2023, 01:06 AM
Last Post: LoneStarCycler
  FAAC 400 cbac LN 104202 obey gates 1 9,054 21-11-2022, 09:54 AM
Last Post: SamA
  FAAC gates help - code change from previous owners trekkerglenn 3 7,690 14-11-2022, 12:03 PM
Last Post: benbrooks
  FAAC sensors and Beninca R16E motor Beachcomber 7 13,059 20-07-2022, 09:50 AM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)