Mag-lock not activating after close

[benkay]

Hi all,

I've got a Toona 4 system with MC284H control box.

I had to re-mount the static end of the actuators and so decided to run another automatic calibration routine to detect the end-stop positions...I then manually set the leaf-overlap and open positions according to the manual.

Previously, all worked well, and a magnetic lock activated after close to lock the leaves in position.

After running the calibration routine again, the mag-lock no longer activates after close.

I checked that the output is set to magnetic lock (and not courtesy light) and confirmed that it is indeed set to magnetic lock function.

Do I somewhere have to tell the control board to activate the magnetic lock? I can't find any reference to this in the manual.

Thanks, Ben

[ldkerlukeHome]

Hi all,

I've got a Toona 4 system with MC284H control box.

I had to re-mount the static end of the actuators and so decided to run another automatic calibration routine to detect the end-stop positions...I then manually set the leaf-overlap and open positions according to the manual.

Previously, all worked well, and a magnetic lock activated after close to lock the leaves in position.

After running the calibration routine again, the mag-lock no longer activates after close.

I checked that the output is set to magnetic lock (and not courtesy light) and confirmed that it is indeed set to magnetic lock function.

Do I somewhere have to tell the control board to activate the magnetic lock? I can't find any reference to this in the manual.

Thanks, Ben

Hi there, did you ever get a resolution of this problem.  My unit has somehow started doing the same - cannot seem to get the magnetic lock to activate and there is no AC or DC voltage output from the unit for the ELS.