Thread Rating:
  • 7 Vote(s) - 2.43 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fine tuning gate stopping point
#1
I inherited a dual 421/455D system a few years go when I purchased a home.  I cannot seem to fine tune the closing points and there is no
way to install a positive stop in the middle of the driveway.  The right operator does not seem to close completely, but the key release does no good
as the travel between locking point is too large.  Im wondering if I can manually rotate the screw jack to fine tune....only need about any extra inch on closing.  Cant find anything in the manual that addresses this issue.   Thanks
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Intermittent ‘Stop’ command - FAAC 741 Sliding Gate bwel 3 2,409 22-04-2024, 03:21 PM
Last Post: JoeF
  Gate continues trying to open tjtj6554 1 4,366 20-09-2022, 08:02 AM
Last Post: SamA
  Faac gate opens when photo cell beam is broken Stephen Q 5 13,602 29-03-2021, 01:53 PM
Last Post: Stephen Q
  FAAC Gate Issue asifrana 0 7,963 26-07-2020, 10:53 PM
Last Post: asifrana
  Trouble keeping gate closed tkalfaoglu 0 7,958 28-06-2016, 10:02 AM
Last Post: tkalfaoglu
  Difficulty installing Faac gate opener grigadale 1 14,603 31-07-2012, 04:17 PM
Last Post: acsys
Question Do I need to use the same manufacturer to replace my gate remote control? danemo 1 13,936 31-03-2011, 12:45 PM
Last Post: easygates

Forum Jump:


Users browsing this thread: 1 Guest(s)