Thread Rating:
  • 268 Vote(s) - 2.82 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Daitem SC9200AU Controller to Nice MC824
#1
Hi,
I've wired the controller up as described in your tech sheet but the controller only opens the gate. I don't have the gates auto closing so would like to be able to close them using the handset. Is this possible?, cheers.
Reply
#2
Ok, figured out how to get it to close. I swapped the wire from terminal 14 from "open" to "PP". The gates now open and close ok but the display always indicates the gates as closed. Is there any way to correct this? Cheers.
Reply
#3
The daitem is only designed to open a gate, then automatically close it "if set on the gate panel" that's why it cannot tell if the gate is open or closed,

(10-10-2014, 12:59 PM)Shropshire fella Wrote: Ok, figured out how to get it to close. I swapped the wire from terminal 14 from "open" to "PP". The gates now open and close ok but the display always indicates the gates as closed. Is there any way to correct this? Cheers.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Nice RB600 - Automatic close fail and opening issues P100D 1 767 30-09-2024, 02:43 PM
Last Post: P100D
  Nice robus not closing Dantay 1 1,064 27-09-2024, 10:17 AM
Last Post: Aiden Mitton
  Nice Walky on 24v dman99 1 1,191 12-08-2024, 03:54 PM
Last Post: Aiden Mitton
  Can a Hormann Bisecur learn a code from a Nice ON2E? ? Noghar 1 2,047 17-07-2024, 02:21 PM
Last Post: JoeF
  Nice Era EPMB 3 flashes not recognised by control unit budda 2 2,204 16-07-2024, 08:47 AM
Last Post: Michael
  nice robus D400 smartphone control YOSH 1 3,283 05-03-2024, 04:45 PM
Last Post: benbrooks
  Nice MC800 Wiring issue Adamzsite 2 3,179 05-03-2024, 04:37 PM
Last Post: Michael
  nice robus troubleshooting tarmongaidon 7 25,573 30-01-2024, 05:19 PM
Last Post: hasanova
  Nice photo sensor issue F210 and MC824H gates won’t operate Tantrum 1 4,695 04-01-2024, 10:06 AM
Last Post: Michael
  Nice Robus RBA3c Wifi Relay Switch Wiring denis 1 3,901 01-11-2023, 09:45 AM
Last Post: Michael

Forum Jump:


Users browsing this thread: 1 Guest(s)