06-05-2014, 02:53 PM
Hi Mate,
The phases on the motors are the wrong way round. You have 3 wires for each motor, the middle of each one is your common, all you need to do is switch the phases round.
Hope this helps
The phases on the motors are the wrong way round. You have 3 wires for each motor, the middle of each one is your common, all you need to do is switch the phases round.
Hope this helps
(18-05-2013, 04:35 PM)glyn Wrote: Hi All
I hope someone can point me in the right direction, i have just installed BFT Virgo gate motors, the motors are mounted on the back of the pllars and i have the gates opening out, it is all wired i have programed the remotes etc and put in a 10sec delay on closing the problem is you press the remote the gates close and 10 sec later they open and stay open (until you press the remote again and the same happens) "they are working in reverse" instructions very poor and i am pulling my hair out, can anybody point me in the right direction,
Cheers
Glyn