Electric Gates, Garage Door, Access Control, Smart Home & Security Forums › Gate Automation and Installation Help › Automatic Gates - Help and Support v
open command

Thread Rating:
  • 214 Vote(s) - 2.98 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
open command
geoffpb
Unregistered
 
#1
16-03-2014, 10:48 PM
Hi,
As you can see by my question I am new to gate automation.

I hame a mhouse WG2 kit and want to use a beam on the inside of double gates to open automaticly to allow vehicles out. Do I use the ECS bus or the open connection point and if the open connection point which of the the pins

Thanks for any help

Geoffpb
Reply


Messages In This Thread
open command - by geoffpb - 16-03-2014, 10:48 PM
RE: open command - by Sav - 18-03-2014, 09:47 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Gates not staying open JimM169 0 128 09-05-2025, 06:26 PM
Last Post: JimM169
  Nice MC824H gate stuck open Markp80 1 3,714 13-05-2024, 02:32 PM
Last Post: Jakedugmore
  Rigel 5 , gates won't open Nameloc 4 6,953 04-05-2024, 12:41 PM
Last Post: Alee
  Came ZA3 gates stuck open Ivorwindybottom 0 1,621 18-02-2024, 06:29 PM
Last Post: Ivorwindybottom
  Disable Open hold On NICE NC824 paul@blxnetworks.co.uk 4 5,357 02-10-2023, 09:20 AM
Last Post: benbrooks
  Holding the Gate Open mgb 1 7,040 11-07-2023, 01:35 PM
Last Post: JoeF
  Came gates stuck open. Ring8180 7 24,633 23-02-2023, 01:08 PM
Last Post: SamA
  Nice gate stuck on open akkers 5 18,340 28-06-2021, 09:43 AM
Last Post: Michael
  Genius Brain 17 Control Board - External Open/Close Signal rhennessysummit 1 6,654 02-05-2021, 09:00 PM
Last Post: soother
  Cost of holding gates open Helen 1 6,925 22-04-2020, 10:59 PM
Last Post: Luke Scott

Forum Jump:


Users browsing this thread: 1 Guest(s)