p7 -45 Ram and Rigal 5

[Blakey111]

The only thing I could recommend would be to start removing devices which has been hard wired into the control panel until the fault clears. Once you have located the problematic device, I would recommend tracing all wiring and make sure there are no shorts. I'd imagine if the arm were damaged internally, there's not a lot you can do other than replace it!
Kindest regards,
Dave

Hi, can any one help.

I have a Rigel 5 control box with p7-45 Ram.

All was well, then the control box came up with a error of ER11.

I phoned BFT and they said bad connection or something going to ground.

If it is the Ram, does anybody know how to check this or get the Ram repaired.