Problem with Proteco Sliding Gate Controller

[JHONNY33]

Hi there.
I have a PROTECO Sliding gate system with this controller:
[Image: proteco.jpg]

This ~is the box/container of the system:
[Image: mover.jpg]

The controller started malfunctioning (strange codes on hexadecimal screen) and the system did not work.

I have been reading the forum and I have removed all cabling as stated here.

Here goes my testings description:
----------------------------------
#TEST 1
Setup: Power / Transformer / Motor / Links on [2-8][3-9][4-9]
Symptoms: I hear a "tick tick" sound in randomly (10 sec interval)
LCD Error: "F="

If I give opening command[1-8] , nothing happens and the lcd error and sympons continue the same. If I try the remote, the led on the controller blinks,nothing happens and error/symptoms continue .


----------------------------------
#TEST 2
Setup: Power / Transformer
LCD Error: "M0"

1. Connect motor.
1.1 LCD Error: "U0" *U = inverted U

2. Then, Connect [2-8] *stop button bypass
2.1 LCD Error: "M0"

3. Then, Connect [3-9] *bypass cells
3.1 LCD Error: "MC"
3.2 Symptoms: I hear a "tick tick" sound in randomly (10 sec interval)

4. Then, Connect [4-9] *bypass cells
4.1 LCD Error: "F=" *as on #test1
4.2 Symptoms: I hear a "tick tick" sound in randomly (10 sec interval)

Again, If I give opening command[1-8] , nothing happens and the lcd error and sympons continue the same. If I try the remote, the led on the controller blinks,nothing happens and error/symptoms continue .


*Note: Nothing else is connected. (no antena, no blinker, no sliding interruptor [5,6], no cell cabling)


Please let me know what I could do to fix this problem. (I can send the board to UK for repair)

Best regards,
John
PORTUGAL