Came gates za3p

[Simon NW]

Hi Simon

I would suggest disconnecting all accessories from the board and run 1 motor at a time. This would determine whether it is a motor issue or a control board issue as i doubt both motors would cause the RCD to trip.

Regards
Easygates 1

It was the courtesy light(s) - new bulbs purchased, reconnected, blew again so no lights. 

Different issue - limit switches are off on the board, but now left hand gate will open, but not close. I am guessing the Limit switch in the ATS30 is knackered (like the right hand gate is)?