Electric Gates, Garage Door, Access Control, Smart Home & Security Forums › Gate Automation and Installation Help › Automatic Gates - Help and Support v
Came gates za3p

Thread Rating:
  • 80 Vote(s) - 2.81 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Came gates za3p
Michael Offline
EasyGates Staff
*******
Posts: 67
Threads: 0
Joined: Feb 2021
Reputation: 1
#4
04-01-2024, 10:12 AM
Hi Simon

I would suggest disconnecting all accessories from the board and run 1 motor at a time. This would determine whether it is a motor issue or a control board issue as i doubt both motors would cause the RCD to trip.

Regards
Easygates 1
EasyGates.co.uk - EasyGates Ltd
 
EasyGates Direct - Trade only accounts.

Smart and Secure Center - Smart Home Products
Find
Reply


Messages In This Thread
Came gates za3p - by Webby - 01-08-2018, 07:41 PM
RE: Came gates za3p - by Automatic-TC - 03-08-2018, 08:42 PM
RE: Came gates za3p - by Simon NW - 03-01-2024, 12:39 PM
RE: Came gates za3p - by Michael - 04-01-2024, 10:12 AM
RE: Came gates za3p - by Simon NW - 07-01-2024, 07:11 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAC gates out of sync TheDock 1 489 21-08-2024, 12:21 PM
Last Post: TheDock
  Rigel 5 , gates won't open Nameloc 4 5,564 04-05-2024, 12:41 PM
Last Post: Alee
  Gates tripped Phil.c 3 1,824 01-05-2024, 09:34 AM
Last Post: Phil.c
  Came ZA3 gates stuck open Ivorwindybottom 0 992 18-02-2024, 06:29 PM
Last Post: Ivorwindybottom
  Electric Gates with AllMatic BIOS2 Unit antsnaith 3 3,863 31-01-2024, 08:22 AM
Last Post: patronsecurity
  Nice Gates not closing StuL 1 3,237 24-08-2023, 01:34 PM
Last Post: JoeF
  Gates Opening After Closing tht7 2 11,188 30-07-2023, 12:30 PM
Last Post: lcpbarbosa
  Came gates stuck open. Ring8180 7 20,410 23-02-2023, 01:08 PM
Last Post: SamA
  Aria 400 - gates keep opening and closing objohnuk 1 5,017 13-04-2022, 11:32 AM
Last Post: JoeF
  Gate Controls/Indicators 200m from Gates ADickson 12 59,962 30-12-2021, 11:44 AM
Last Post: herberthaul

Forum Jump:


Users browsing this thread: 1 Guest(s)