Disable Open hold On NICE NC824

[benbrooks]

Hi Ben,
  The control unit is a MCA1 ITEM: MCA1R10 is the information on the label on the front.
  The issue is the hold open, it can be triggered by a second "open" request from the Paxton reading a card, or by a vehicle driving inwards and over the induction loop following the first open request, i have witnessed the second "open" command and the gates do remain in the open position until a further "open" request at which point they fully open then close after the timeout.

Hi,

It is possible that the gate is receiving a second command then, which will result in the gates holding open.

To fix this condominium mode / apartment block would need to be activated on your step-by-step function. Instructions on how to do this can be found on page 8 of the PDF document.

https://manuals.easygates.co.uk/PDF/nice/D00011568.pdf

Regarding if the oview will work on both MC824H and the M800, yes it will as both panels have a IBT4N connection which is needed when plugging the Oview in.

Many thanks

Ben