Thread Rating:
- 12 Vote(s) - 3 Average
- 1
- 2
- 3
- 4
- 5
|
Faac gate opens when photo cell beam is broken
|
Posts: 5
Threads: 2
Joined: Mar 2021
Reputation:
0
(29-03-2021, 09:50 AM)RyanB Wrote: My apologies Stephen. It looks like the photocells were used as a device to open the gates when approached. This would also open the gates while they were closing. Revising what I have advised previously you will have a green and white wire going into 9 and 14. The wire going into 9 would need to be moved to 12 and 14.
Wiring diagram for 1 x Closing Photocells:
If you already have closing photocells wired into these terminals you will need to wire these as shown in the image below.
Wiring diagram for 2x Closing Photocells:
|
| Messages In This Thread |
RE: Faac gate opens when photo cell beam is broken - by Stephen Q - 29-03-2021, 01:51 PM
|
| Possibly Related Threads… |
| Thread |
Author |
Replies |
Views |
Last Post |
| |
FAAC Eq45s , only Leaf A closing with remote |
Cummil2 |
1 |
767 |
13-03-2025, 10:06 AM
Last Post: benbrooks
|
| |
FAAC Eq45s , only Leaf A closing with remote |
Cummil2 |
1 |
748 |
13-03-2025, 10:05 AM
Last Post: benbrooks
|
| |
FACC sliding gate not responding. |
Kipod |
2 |
1,497 |
09-12-2024, 09:24 AM
Last Post: nicenotnice
|
| |
FAAC S800 Single swing Gate not responding |
robhight |
0 |
1,548 |
18-11-2024, 11:48 AM
Last Post: robhight
|
| |
FAAC Configure 443Hz remote to open partially, pause and close |
Ezylryb |
1 |
1,563 |
12-08-2024, 03:52 PM
Last Post: Jakedugmore
|
| |
FAAC problem |
dennisoates |
0 |
1,288 |
30-06-2024, 04:40 PM
Last Post: dennisoates
|
| |
Intermittent ‘Stop’ command - FAAC 741 Sliding Gate |
bwel |
3 |
4,442 |
22-04-2024, 03:21 PM
Last Post: JoeF
|
| |
Faac 415 can't reset from manual to operate mode |
Stephen Q |
1 |
4,039 |
18-03-2024, 01:20 PM
Last Post: RXH
|
| |
Faac 455d |
Grantplant |
1 |
4,956 |
13-11-2023, 11:58 AM
Last Post: Aiden Mitton
|
| |
FAAC 740 limited travel |
LoneStarCycler |
0 |
4,668 |
24-06-2023, 01:06 AM
Last Post: LoneStarCycler
|
Users browsing this thread: 1 Guest(s)
