Thread Rating:
  • 247 Vote(s) - 2.81 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Installing Nice photo sensors MC424
#6
when using photocells on the MC424 for safety the NC and C relay connections are required to be used.
The connections you wire these into are either Photo or Photo1 and the common.

Photo = Only work when gates are closing, gates will stop and reverse.
Foto1 = Work when gates are opening and closing. When opening the gates will stop until the obstruction is removed and will then continue. When closing gates will stop and reverse
Gate Automation and Access Control from EasyGates Retail Store

EasyGates Trade Store for Trade only

Smart Home Tech from The Smart and Secure Centre

Smart Home News from Smart Home Matters
Reply


Messages In This Thread
Installing Nice photo sensors MC424 - by polomint - 04-08-2016, 03:24 PM
RE: Installing Nice photo sensors MC424 - by Sav - 05-08-2016, 12:16 PM
RE: Installing Nice photo sensors MC424 - by RyanB - 14-04-2020, 01:20 PM
RE: Installing Nice photo sensors MC424 - by SamA - 29-03-2021, 01:30 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  NICE gates open slightly then stuck Overthefence 1 267 11-05-2025, 07:31 PM
Last Post: Overthefence
  Nice Robus 250 HS Fuse Problem GLM 1 660 09-05-2025, 01:07 PM
Last Post: Aiden Mitton
  Looking for help with oldschool NICE gate motor gatekeeper 0 1,498 16-02-2025, 05:16 PM
Last Post: gatekeeper
  Diagnosing Nice SFAB2024 (ex XME2024) Motors devlinjayse 0 1,463 08-02-2025, 07:22 PM
Last Post: devlinjayse
  Nice RB600 - Automatic close fail and opening issues P100D 6 5,088 10-12-2024, 11:29 AM
Last Post: P100D
  Nice MC824H Set Up issue dmrgate 2 3,441 10-12-2024, 10:31 AM
Last Post: dmrgate
  Nice O-Box Software Andruelectricgates 1 2,620 09-12-2024, 12:52 PM
Last Post: JoeF
  Reclose after photo with exit loop Wilson316 0 745 20-11-2024, 06:18 PM
Last Post: Wilson316
  Nice robus not closing Dantay 1 3,346 27-09-2024, 10:17 AM
Last Post: Aiden Mitton
  Nice Walky on 24v dman99 1 2,555 12-08-2024, 03:54 PM
Last Post: Aiden Mitton

Forum Jump:


Users browsing this thread: 2 Guest(s)