cb24

[JWils]

Hi
I have a CB24 gate opener and it's been ok since I fitted it two years ago - following a minor reset the gate has developed a small glitch. It is fitted with a solenoid latch to lock the gate when it closes but it has started to hang on energised for a couple of seconds when it closes and misses the latch since there is a slight bounce back when the gate contact the stop. This means the gate is not in the lock position when it finally does de energise. What is the correct format for programming the solenoid since the book only gives it for Maglock which is different.
Thanks

[Mark]

Hi
I have a CB24 gate opener and it's been ok since I fitted it two years ago - following a minor reset the gate has developed a small glitch. It is fitted with a solenoid latch to lock the gate when it closes but it has started to hang on energised for a couple of seconds when it closes and misses the latch since there is a slight bounce back when the gate contact the stop. This means the gate is not in the lock position when it finally does de energise. What is the correct format for programming the solenoid since the book only gives it for Maglock which is different.
Thanks

The CB24 is designed to work best with Magnetic Locks which work in a completly opposite to the Solonoid lock.

The Gate system need to be set as to not have any bounce back so the lock will engage this is just a case of trial and error programming it to best effect there is no adjustments for the time the lock engages and dissengages.