26-07-2025, 11:47 PM
hi all,
I have a BFT Demios A600 and have been battling with a bAr error for several weeks, with no clear symptoms. Suddenly woke up one morning and the gate would not function.
I opened the box to jump 70/71 to bypass the photocells but this didn’t work. I also tried jumping 72/73 and 74/75, with all the various combinations. This showed a STOP error, which I then tried to resolve by jumping 60/61. From this point on, I was shown Stre, irregardless of what I tried to do. I tried multiple times to go through the setup (lang, autoset etc), but the gate will not move hence it will result in KO.
I should also note that only one photocell clicks, not sure if that should be the case or not?
Any ideas what I can do to resolve this? I’ve returned the wiring to the original, and I’m getting the bAr error again. Photo attached (note there was a brown wire between 70/71 when I originally opened the box, which I haven’t bothered to replace).
I have a BFT Demios A600 and have been battling with a bAr error for several weeks, with no clear symptoms. Suddenly woke up one morning and the gate would not function.
I opened the box to jump 70/71 to bypass the photocells but this didn’t work. I also tried jumping 72/73 and 74/75, with all the various combinations. This showed a STOP error, which I then tried to resolve by jumping 60/61. From this point on, I was shown Stre, irregardless of what I tried to do. I tried multiple times to go through the setup (lang, autoset etc), but the gate will not move hence it will result in KO.
I should also note that only one photocell clicks, not sure if that should be the case or not?
Any ideas what I can do to resolve this? I’ve returned the wiring to the original, and I’m getting the bAr error again. Photo attached (note there was a brown wire between 70/71 when I originally opened the box, which I haven’t bothered to replace).
