26-04-2019, 08:20 PM
Hi,
I hope you can assist in diagnosing a problem which I have with my 2no. GIBIDI articulated arm 24v motors fixed to brick piers which operate a pair of metal gates with 2no. photocells.
On an increasingly frequent basis the gates fail to fully close leaving a gap of about 300mm between opening leaves. When re-opening the gates they close OK........ until the next time the problem occurs!
Any assistance would be appreciated.
Regards
David
I hope you can assist in diagnosing a problem which I have with my 2no. GIBIDI articulated arm 24v motors fixed to brick piers which operate a pair of metal gates with 2no. photocells.
On an increasingly frequent basis the gates fail to fully close leaving a gap of about 300mm between opening leaves. When re-opening the gates they close OK........ until the next time the problem occurs!
Any assistance would be appreciated.
Regards
David