Nice RB600 - Automatic close fail and opening issues

[P100D]

Hello,

Hope everyone is doing fine.
I have a Robus RB600 gate and have 2 issues I'd need help with.
1. The automatic close is enabled, however it only works if nothing passes through the gate during that time. If a car or a person breaks the the photo beam during this time, it will not auto close anymore...

2. During the opening, if a car passes before the gate is fully opened, the door halts at that point, and will not continue to open as it should. tried various settings w/o any success.

I would really appreciate any help with this.

Many thanks in advance!

[P100D]

Bump up! 38 views and no answer....Would really appreciate any help with these issues, Thanks!

[nicenotnice]

Did you solve this issue? currently facing the same problem

[P100D]

Did you solve this issue? currently facing the same problem

Unfortunately not yet. But I realized this place is a place for questions NOT answers…

[Michael]

Hi,

The board is receiving a second command. If you could call through to the number below, we can assist you on this.

01384569942
Regards
Easygates Ltd

[nicenotnice]

Did you solve this issue? currently facing the same problem

Unfortunately not yet. But I realized this place is a place for questions NOT answers…

Have you tried to connect to SBS and programming in apartment block? tried and it works for us.

[P100D]

Hi,

The board is receiving a second command. If you could call through to the number below, we can assist you on this.

01384569942
Regards
Easygates Ltd

Thanks, appreciate the offer. I was hoping to get the info (which seems to be trivial to an experienced gate installer) here, w/o paying for it, that is why I posted the screenshots of my configuration...

Best!