Thread Rating:
  • 358 Vote(s) - 2.89 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LYN300 closing problem
#2
Furhter investigation reveals; with nothing connected to 'close photo' input, the red LED adjacent to that input stays lit even though switch 5 of S1 is set to normally open.
With switch 5 set to normally closed and a wire bridge in 'close photo' input then gates work OK but the close sensor is obviously not functioning. sounds like a main board failure to me but expert opinion would be appreciated.
Reply


Messages In This Thread
LYN300 closing problem - by whitegatenorm - 23-12-2008, 05:57 PM
RE: LYN300 closing problem - by whitegatenorm - 26-12-2008, 05:42 PM
RE: LYN300 closing problem - by Mark - 02-01-2009, 02:04 PM
RE: LYN300 closing problem - by whitegatenorm - 04-01-2009, 11:55 AM
RE: LYN300 closing problem - by whitegatenorm - 10-01-2009, 02:50 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Difference: SCS300, LYN300, and LYN400? DevsAd 3 4,810 02-03-2023, 03:12 PM
Last Post: SamA
  Problem with delay time CB11 milan 2 11,654 04-10-2021, 01:44 AM
Last Post: DesmondVog
  Lyn300 lubrication Capricious 5 11,761 08-06-2021, 12:37 PM
Last Post: Capricious
  Sliding gates are opening/closing like someone is going in /out. gandreja 3 10,288 14-04-2020, 01:45 PM
Last Post: RyanB
  Chamberlain Liftmaster gate problem CB1 Armstrong 2 31,759 13-06-2019, 11:46 AM
Last Post: Pop Alexandra
  CB22 problem??? Bakota 0 9,466 16-11-2014, 02:25 PM
Last Post: Bakota
  Remote problem Nickhh 1 10,326 30-09-2014, 04:48 PM
Last Post: Technologic Systems
  liftmaster CB11 hold gate open problem sparkey 5 32,472 13-05-2013, 08:17 AM
Last Post: brucekwilles
  Problem with CB11 Board Michael 1 12,094 08-05-2013, 11:32 AM
Last Post: Mark
  LYN300/400 thermiclance 0 7,654 29-10-2012, 08:58 AM
Last Post: thermiclance

Forum Jump:


Users browsing this thread: 1 Guest(s)