Thread Rating:
  • 8 Vote(s) - 2.88 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GIBIDI gate motor closing problem
#1
Hi,

I hope you can assist in diagnosing a problem which I have with my 2no. GIBIDI articulated arm 24v motors fixed to brick piers which operate a pair of metal gates with 2no. photocells. (As attached photos show).

On an increasingly frequent basis the gates fail to fully close leaving a gap of about 300mm between opening leaves.  When re-opening the gates they close OK........ until the next time the problem occurs!

Any assistance would be appreciated.

Regards

David.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Hello and advice on Beninca RF tranmitter problem JKR2 1 1,490 12-08-2024, 03:47 PM
Last Post: JoeF
  Gibidi gate opener. Add a wired switch. Eagle_man 1 10,047 30-11-2021, 01:23 PM
Last Post: JamieF
  Beninca sliding gate. Rogeramjet 1 6,570 22-11-2021, 06:14 PM
Last Post: Asaded
  FAAC GATES NOT CLOSING Slick19000 0 3,710 21-07-2021, 01:45 PM
Last Post: Slick19000
  Problem with CB22 Larry 1 7,961 17-03-2021, 10:57 AM
Last Post: Michael
  Hello Looking for gate control help everettc4 1 7,191 05-02-2021, 01:12 PM
Last Post: JamieF
  Hi All BFT ALTAIR-P gates not closing michaelo76 0 5,501 13-08-2018, 05:47 PM
Last Post: michaelo76
  Inherited GiBiDi Gate Shuggy73 2 13,527 13-04-2018, 05:18 PM
Last Post: Shuggy73
Cool Hello :) Gate/Barrier Engineer MrDiagnostics 0 8,032 29-04-2017, 09:48 AM
Last Post: MrDiagnostics
  Mhouse Swing gate rmgsecurity Sri Lanka 0 7,269 12-11-2016, 03:00 AM
Last Post: rmgsecurity Sri Lanka

Forum Jump:


Users browsing this thread: 1 Guest(s)