28-09-2020, 07:48 PM
Hi,
I have a FROG motor installation with 2x swing gates.
In place working well for 7 yrs (except for slugs taking out 2 x pcb boards)
Today, one side will not close. It attempts to close but then stops and goes back to fully open.
Even when I run the encoder test, the same thing happens (M1 opens fully and M2 tries to close and stops after a few inches of travel.
I only have photocells as a safety input device.
Any thoughts to the problem here?
Thank you,
Mike
I have a FROG motor installation with 2x swing gates.
In place working well for 7 yrs (except for slugs taking out 2 x pcb boards)
Today, one side will not close. It attempts to close but then stops and goes back to fully open.
Even when I run the encoder test, the same thing happens (M1 opens fully and M2 tries to close and stops after a few inches of travel.
I only have photocells as a safety input device.
Any thoughts to the problem here?
Thank you,
Mike