BFT Rigel 4 with BFT Sub

[barrett30104387]

Hi there,

I am trying to get my gates in a functional state. They've been sat idle for a good 5 years. Now I'm pretty new to Gate automation, so any help would be great! 

I have M1 and M2 working but I am failing at solving how to adjust the run time on the gates? M2 runs and stops where I would like but M1 over runs. I am only getting them to open and close via turning the power on and off. I have replaced the oil in both but its the operation of the gates is what I am struggling with.

Any help would be great!

Thankyou in advance!

[Tim]

Hi,

Thank you for your enquiry, if you let use know what system you are using (Manufacture name and model number of motors and control board) then we can send you a manual on how to adjust the programming setting on the board.
Kind regards
Tim