Thread Rating:
  • 262 Vote(s) - 2.92 Average
  • 1
  • 2
  • 3
  • 4
  • 5
lift master SCS300 - photocells
#1
Exclamation 
Hi there, first post and looking for some help.
I have a lift master scs300 kit 24v for a double gate installed. The problem I'm experiencing is that the gates will not close. I be read previous threads but can't seem to find the solution.
The only difference I notice is that the chamberlain 771E model photocells stay flashing (pic attached) external to the gate as if there is an obstruction but this is not the case. I opened up both covers to clean around sensor but no change.
I reset system by turning off mains power and removing battery for a while. I turned it back on and then reset gate limits which ended in the closed position. I have a GSM UNIT rang the gates they opened but still will not close.
Can this be as simple as replacing photocells or is there something else I can try?
Thanks in advance
Reply
#2
Can the photocells be removed temporarily so that the gate will close ??
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Difference: SCS300, LYN300, and LYN400? DevsAd 3 4,886 02-03-2023, 03:12 PM
Last Post: SamA
  odd liftmaster scs300-24 scopie88 3 14,274 13-04-2022, 10:20 AM
Last Post: JoeF
  Adding Extra Photocells To CB22 Onoff 0 5,560 06-08-2020, 01:01 AM
Last Post: Onoff
  chamberlain photocells wlehane 3 28,675 02-09-2019, 10:00 AM
Last Post: Sav
Exclamation lift master SCS300 - photocells Willow 0 8,385 13-07-2016, 11:19 AM
Last Post: Willow
  Opening delay on SCS300 (CB124 board) willows79 0 9,015 02-12-2015, 09:45 PM
Last Post: willows79
  cb24 photocells devonaloan 1 11,640 28-11-2011, 05:57 PM
Last Post: Mark
  CB24 Kit with a single set of photocells JD1765 1 19,241 07-06-2010, 10:04 AM
Last Post: easygates
  Photocells crafty 1 13,008 12-01-2010, 03:29 PM
Last Post: easygates
  Wiring Photocells on the CB11 control board Sparky 2 22,759 28-06-2009, 10:19 PM
Last Post: Sparky

Forum Jump:


Users browsing this thread: 2 Guest(s)