18-05-2018, 07:57 PM
Hi
Photocell has 5 terminals 1&2 power 3 com 4 no & 5 nc I tried to connect stop to 3&4 then 3&5 but didn't seem to make any difference. I also reset bluebus each time as it said on installation manual. I have the gate set to auto close after 15 seconds so I thought that if stop was activated gate would auto close after 15 seconds. If photocell is triggered whilst gate is opening it also causes gate to stop. I want gate to open if gate is closing and photocell is activated then close automatically after pause time.
Thanks for any help.
Les
Photocell has 5 terminals 1&2 power 3 com 4 no & 5 nc I tried to connect stop to 3&4 then 3&5 but didn't seem to make any difference. I also reset bluebus each time as it said on installation manual. I have the gate set to auto close after 15 seconds so I thought that if stop was activated gate would auto close after 15 seconds. If photocell is triggered whilst gate is opening it also causes gate to stop. I want gate to open if gate is closing and photocell is activated then close automatically after pause time.
Thanks for any help.
Les