Gates out of sync
|
Gates out of sync
|
07-01-2018, 03:25 PM
(07-01-2018, 10:38 AM)frankjboyd Wrote: I have a set of double gates that are operating with the came frog system. The problem that just developed, is the gates are out of sync. The left side opens while the right side is closing. Would appreciate any help or suggestions on this senario hi that's happened probably because of cold weather . can i know the control board type / name is this za3 ?? regards Best Regards
Tom
Automatic-TC
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gates out of sync - by frankjboyd - 07-01-2018, 10:38 AM
RE: Gates out of sync - by Automatic-TC - 07-01-2018, 03:25 PM
RE: Gates out of sync - by Murphe5 - 31-12-2022, 01:28 PM
RE: Gates out of sync - by Murphe5 - 31-12-2022, 01:31 PM
RE: Gates out of sync - by Murphe5 - 03-01-2023, 04:14 PM
RE: Gates out of sync - by SamA - 05-01-2023, 11:52 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Gates not closing | Regor23 | 5 | 3,892 |
03-09-2024, 12:51 PM Last Post: Ivorwindybottom |
|
| Came FROG-A + ZA3 controller > gates wont close safety beam | endam | 6 | 13,468 |
23-02-2023, 01:09 PM Last Post: SamA |
|
| Came Gates Error code E14 | janker | 3 | 11,139 |
14-11-2022, 11:59 AM Last Post: benbrooks |
|
| My Came ZM3E gates won’t open | golfnut75 | 1 | 8,949 |
12-08-2022, 08:40 AM Last Post: SamA |
|
| ZA3 Came gates not opening with RF device | chooper | 5 | 12,167 |
24-06-2022, 08:58 AM Last Post: JoeF |
|
| Came Gates - power cut issues | Paddy_SP | 2 | 10,683 |
22-07-2021, 09:42 AM Last Post: Paddy_SP |
|
| Came Double Swing Gates opens by itself for some centimeters | risp73 | 0 | 9,493 |
19-06-2020, 06:19 PM Last Post: risp73 |
|
| Came gates | Ring8180 | 1 | 83,453 |
10-07-2019, 10:39 AM Last Post: JoeF |
|
| Frog - ZA3: gates won't open | BarryD | 0 | 11,172 |
15-06-2016, 01:34 PM Last Post: BarryD |
|
| CAME double gates - one side closes but will not open | crliving | 1 | 20,034 |
02-08-2013, 09:39 AM Last Post: Blakey111 |
|
