Thread Rating:
  • 201 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC 740 - help needed!
#6
Hi,

I already had it removed from the equation. there isn't any cells configured and the motor is running in without any other signal. The only signal that it receives is the remote, but that is only when I press the command.

Sad

Any other suggestion?

Regards,
Norberto

(12-12-2016, 08:14 AM)Automatic-TC Wrote: hi

ok ,status 2 mean that the gate was stop by some external signal (remote,button,loop)
if you got instaled some paralel signal wires you should disconect them for short time and live motor operated only from remote control
Reply


Messages In This Thread
FAAC 740 - help needed! - by norberto - 19-10-2016, 07:06 PM
RE: FAAC 740 - help needed! - by norberto - 10-11-2016, 06:25 PM
RE: FAAC 740 - help needed! - by Automatic-TC - 11-12-2016, 10:45 AM
RE: FAAC 740 - help needed! - by norberto - 12-12-2016, 12:23 AM
RE: FAAC 740 - help needed! - by Automatic-TC - 12-12-2016, 08:14 AM
RE: FAAC 740 - help needed! - by norberto - 12-12-2016, 10:43 AM
RE: FAAC 740 - help needed! - by Automatic-TC - 12-12-2016, 06:44 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Help needed sourcing manual release key - Chamberlain HC300 pb3000 1 299 10-08-2025, 03:32 PM
Last Post: pb3000
  FAAc xp20d wiring Neil Young 4 3,334 04-02-2025, 12:08 PM
Last Post: Neil Young
  FAAC gates out of sync TheDock 1 2,275 21-08-2024, 12:21 PM
Last Post: TheDock
  Faac 452 pcb board benner91 2 5,142 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 5,913 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  FAAC E124 fault 05 allan@amtas.com.au 0 2,634 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 7,675 03-07-2023, 08:54 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 3,249 23-06-2023, 03:19 PM
Last Post: Alpin
  FAAC Photocells mmc1977 3 6,380 02-05-2023, 12:37 PM
Last Post: Matt Turner
  water damage to FAAC photocell Rajab 4 7,525 18-07-2022, 09:00 AM
Last Post: Michael

Forum Jump:


Users browsing this thread: 1 Guest(s)