31-07-2016, 09:22 PM
(This post was last modified: 31-07-2016, 09:24 PM by roadrunner.)
Hi,
I've been trying to program additional mitto remotes and the up/down/ok switches on the QSC board are not doing anything. The LED display is stuck on 'cLS' and only changes to when the gate is opening and closing.
Otherwise the gate still opens and closes fine, together with the flashing strobe working.
Is it possible that incorrect wiring on terminals 21 to 26 could have caused this? I replaced a worn motor a few years ago and whilst I'm reasonably certain I put everything back correctly I may have made an error.
Also this unit drives external lighting on/off via terminals 12/13 I believe.
Would be grateful for any pointers.
Best regards,
I've been trying to program additional mitto remotes and the up/down/ok switches on the QSC board are not doing anything. The LED display is stuck on 'cLS' and only changes to when the gate is opening and closing.
Otherwise the gate still opens and closes fine, together with the flashing strobe working.
Is it possible that incorrect wiring on terminals 21 to 26 could have caused this? I replaced a worn motor a few years ago and whilst I'm reasonably certain I put everything back correctly I may have made an error.
Also this unit drives external lighting on/off via terminals 12/13 I believe.
Would be grateful for any pointers.
Best regards,