10-05-2015, 08:23 PM
(This post was last modified: 10-05-2015, 08:24 PM by hwjr_easygates.)
Hi,
After arriving this afternoon the gate opened fine, then when closing the gate suddenly openend very fast again. They gate was stuck in open. In the CB11 the red close light was flashing.
In the photocells the lights were all OFF, they are not obstructed by anything. How do I find out if the problem originates from the CB11 power/board, or that the photocells are broken. It is very awkward that they would both fail and loose their respective led/power at the same time.
Should there be 24v between "common" and "close", I measured about 15v. Can I test the photocells in some way?
I have bypassed the photocells for the time being; however, I would like the safety feature reenabled asap.
Anybody encountered this before?
After arriving this afternoon the gate opened fine, then when closing the gate suddenly openend very fast again. They gate was stuck in open. In the CB11 the red close light was flashing.
In the photocells the lights were all OFF, they are not obstructed by anything. How do I find out if the problem originates from the CB11 power/board, or that the photocells are broken. It is very awkward that they would both fail and loose their respective led/power at the same time.
Should there be 24v between "common" and "close", I measured about 15v. Can I test the photocells in some way?
I have bypassed the photocells for the time being; however, I would like the safety feature reenabled asap.
Anybody encountered this before?