Wireless intercom

[Mark]

If you are sure this is a switched output,
You need to wire this 12 v output to a suitable relay(12volt dc, into the coil terminals, normally marked up A1 and A2), run a cable to the control panel, on the relay use 1 core to the common, and another core to n/o. then at the cntl panel end, use the same 2 cores into open and common.

should work.....

carl.

Thanks Carl think I understand, as for the switched output, the handset indoors has a unlock button on it to push?.

Any Easier option would be to use Our Handy relay Module DBR200 which are priced at £12+vat