Thread Rating:
  • 6 Vote(s) - 2.67 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LCA 70 safety issue
#2
(13-08-2025, 11:49 AM)cully Wrote: Please advise,
I have a Ditec LCA 70 control panel with a safety issue "1-8" flashing
The following is what I have tried to resolve this issue
Checked the Prastel sensors for alignment, beam lit on transmitter and interupted when I cover the receiver Ok
Put new batteries in the receiver (Voltage ok)
Swapped both Prastel transmitter and receiver for a spare pair I had, cannot remember why I ended up with spares but the same fault showing
Put a jumper between com and 8 in the control panel to take out the safety circuit, gates work ok.
I'm not an electrician so in order to check the cabling between photocell com and NC I ran a new pair of wires photocell to control panel, still got the fault
Have I missed something? could the issue be in the control panel circuitry?
Thanks for any help

Hi,

It could be a possible board issue have you metered the voltage at the output on the board which the photocells are wired to to see if they are getting adequate voltage?
Reply


Messages In This Thread
LCA 70 safety issue - by cully - 13-08-2025, 11:49 AM
RE: LCA 70 safety issue - by Jakedugmore - 15-08-2025, 01:44 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Bininca photocell wiring issue Hsj 1 5,248 22-03-2024, 12:48 PM
Last Post: JoeF
  Safety Edges Jaddis 1 12,073 30-03-2022, 02:02 PM
Last Post: JoeF
  Swing gate safety edge Forum Flyer 1 15,320 17-03-2020, 10:16 AM
Last Post: JoeF
  Safety bar Jan Hinks 1 34,291 27-10-2014, 03:31 PM
Last Post: Sav
Question Electric Gate Safety Poll easygates 0 21,127 11-04-2012, 10:23 AM
Last Post: easygates
  EGD and ASO 2nd Gate Safety Conference easygates 0 20,332 05-03-2012, 03:40 PM
Last Post: easygates
Question Electric Gate Safety Issues easygates 2 30,917 23-06-2011, 11:27 AM
Last Post: easygates

Forum Jump:


Users browsing this thread: 1 Guest(s)