18-09-2024, 03:35 PM
Hello,
the output from 12-13 is set to be a courtesy light and stay on for 90 seconds following movement.
in my application its used to energise a relay that operates 4 lights along the drive.
It's worked for a couple of years, then stopped. the relay is not energising from the terminals 12-13 output.
I measured this and the voltage is very low, perhaps 3 volts AC.
I'm looking for what relay is used for the output to terminals 12-13 a make / manufacturer in order to replace it rather than a whole new board.
the output from 12-13 is set to be a courtesy light and stay on for 90 seconds following movement.
in my application its used to energise a relay that operates 4 lights along the drive.
It's worked for a couple of years, then stopped. the relay is not energising from the terminals 12-13 output.
I measured this and the voltage is very low, perhaps 3 volts AC.
I'm looking for what relay is used for the output to terminals 12-13 a make / manufacturer in order to replace it rather than a whole new board.