Thread Rating:
  • 6 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Faac photocell stopped working
#1
Hi

Yesterday my Faac gate would no longer open.
   
To me, it seems that this is due to a photocell.

Normally the sensors on one side always give 2 blue leds.
When standing in front of the sensor only one light should be on.

Now, there is 1 photocell that always shows only 1 blue led.
The photocell was wet inside. Drying it solved the problem, although it took a while before both the leds where on again. 
A couple hours laters, the same problem occurred. Only one led was on while there was no obstruction. It did't rain during these hours. 
I can't manage to solve this.
 
Thanks in advance for any help.
Reply


Messages In This Thread
Faac photocell stopped working - by Zeb Gulickx - 01-01-2024, 01:46 PM
RE: Faac photocell stopped working - by benbrooks - 12-01-2024, 09:59 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAC gates out of sync TheDock 1 474 21-08-2024, 12:21 PM
Last Post: TheDock
  Faac 452 pcb board benner91 2 2,844 09-02-2024, 06:13 PM
Last Post: benner91
  Photocell Problem marcoos_1 4 21,759 04-01-2024, 10:23 AM
Last Post: JoeF
  FAAC E124 fault 05 allan@amtas.com.au 0 1,198 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 5,713 03-07-2023, 08:54 AM
Last Post: Michael
  Rigel 5 - second keypad stopped working HarefieldHse 1 2,304 03-07-2023, 08:48 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 1,767 23-06-2023, 03:19 PM
Last Post: Alpin
Exclamation Proteco Q60A stopped working xCO 0 1,379 19-06-2023, 01:03 PM
Last Post: xCO
  FAAC Photocells mmc1977 3 3,698 02-05-2023, 12:37 PM
Last Post: Matt Turner
  Nice Robus RB100 - Control Board Buttons Not Working sl991 5 5,693 02-12-2022, 02:51 PM
Last Post: JoeF

Forum Jump:


Users browsing this thread: 1 Guest(s)