24-08-2023, 01:43 PM
Hi Steve,
First you will need to identify which set are causing the issue. i would firstly...
Remove the covers of the photocells (clean them)
Remove one set from the board and link out the terminals for that photocell input. to see whether the fault disappears.
Check for continuity between the cables there could be a break, if you don't have a meter to test this, run fresh cable above ground temporarily.
Regards
Easygates Ltd
First you will need to identify which set are causing the issue. i would firstly...
Remove the covers of the photocells (clean them)
Remove one set from the board and link out the terminals for that photocell input. to see whether the fault disappears.
Check for continuity between the cables there could be a break, if you don't have a meter to test this, run fresh cable above ground temporarily.
Regards
Easygates Ltd
EasyGates.co.uk - EasyGates Ltd
EasyGates Direct - Trade only accounts.
Smart and Secure Center - Smart Home Products
EasyGates Direct - Trade only accounts.
Smart and Secure Center - Smart Home Products