Adding AES Gate Intecom / Opener to SEA Controller

[TyperViper]

Hi All,

Has anyone got any experience of adding an additional input onto a SEA 54001154-59 Gate Controller to open it?

I have gone through all the wiring diagrams and to test wired across CN1 Pins 2 and 3 to test and would expect for the gate to open but the controller screen just changes to STOP so detects the input but doesn't open

I have attached a pic of the controller and really appreciate anyone help or advise as very frustrating!

Thanks

Hi,

Thanks for the message,

these are the correct inputs however, i would like to check where you are connected from is the NO1 and COM or NC?

Hi JoeF

Thanks for the reply, i can connect to either as long as it opens as the AES has Relay outputs but i just cant see to get anything other than STOP on the controller screen.

Ideally i would want to go to NO Contact and then the replay will close and open the gates like the remote function fully. I dont want to have it open as a PEDOPEN

Thanks in advance