19-04-2020, 07:54 AM
Hi hope you can help.
Just installed this but at this stage have nothing connected other than the arm.
I go through the learning process, set the gate at half way point, it duly opens then closes, the opens again and stops. I expected it to close then it would have learned. I press open close buttons but nothing. I'm sure I must be making a simple mistake. I have dipswitch set for 4 for to5024, have also tried dipswitch 1. Appreciate any advice/help.
Once I have achieved this I will then add bluebus/remote, etc.
Thanks
Just installed this but at this stage have nothing connected other than the arm.
I go through the learning process, set the gate at half way point, it duly opens then closes, the opens again and stops. I expected it to close then it would have learned. I press open close buttons but nothing. I'm sure I must be making a simple mistake. I have dipswitch set for 4 for to5024, have also tried dipswitch 1. Appreciate any advice/help.
Once I have achieved this I will then add bluebus/remote, etc.
Thanks