Remote Control

[easygates]

did you get this problem solved as i am having exactly the same problem

Hi, Make sure the radio card is connected correctly and all pins are connected. Try taking it out and re-inserting it just to make sure you have it plugged in correctly.

Have you tried another remote control? Or replaced the batteries in the one you are using?

Have you set up the photocells? you do this by turning the power off, placing a jumper over the terminals labelled "Save Fail Safe Photocells", then turning the power back on and removing the jumper after 15 seconds.

Check the "Stop" circuit is connected, there should be a link between "Stop" and "Com".

Hope this helps,