22-04-2009, 03:58 PM
Hi, Have you set up the photocells? you do this by turning the power off, placing a jumper over the terminals labelled "Save Fail Safe Photocells", then turning the power back on and removing the jumper after 15 seconds.
Check the "Stop" circuit is connected, there should be a link between "Stop" and "Com".
Also check your radio board is plugged into the CB11.
Hope this helps,
Check the "Stop" circuit is connected, there should be a link between "Stop" and "Com".
Also check your radio board is plugged into the CB11.
Hope this helps,
Gate Automation and Access Control from EasyGates Retail Store
EasyGates Trade Store for Trade only
Smart Home Tech from The Smart and Secure Centre
Smart Home News from Smart Home Matters
EasyGates Trade Store for Trade only
Smart Home Tech from The Smart and Secure Centre
Smart Home News from Smart Home Matters