moovo XW432 keeps powering down

[Paul]

Hi ,
Can anyone advise me what to do - I've recently installed the Volvo XW432 PE automation system - followed the installation manual religiously.
All working fine ,but every now and then the system goes into shutdown and I don't know why.
I have turn the power completely off and on again then it works fine again

Would appreciate some advise on this

[Automatic-TC]

Hi ,
Can anyone advise me what to do - I've recently installed the Volvo XW432 PE automation system - followed the installation manual religiously.
All working fine ,but every now and then the system goes into shutdown and I don't know why.
I have turn the power completely off and on again then it works fine again

Would appreciate some advise on this

hi
did you instal flashing lamp as well ?
how many times this gate is opened per day ?

[Paul]

Hi ,
Can anyone advise me what to do - I've recently installed the Volvo XW432 PE automation system - followed the installation manual religiously.
All working fine ,but every now and then the system goes into shutdown and I don't know why.
I have turn the power completely off and on again then it works fine again

Would appreciate some advise on this

hi
did you instal flashing lamp as well ?
how many times this gate is opened per day ?

---

Yes I have fitted the lamp .
We can leave the gates over night and sometimes they open and sometimes they won't.
The lamp don't indicate any faults - so we turn power off then on and they work fine for a while
Thanks for your help

[Automatic-TC]

Such faults are the worst, it may be some slack on the control panel connector or in bluebus connections

[Paul]

Such faults are the worst, it may be some slack on the control panel connector or in bluebus connections

So what can I do to correct it ?

[Automatic-TC]

hi

open all of the devices and check conections , test photocells if lined up and finally program control board once again

[Paul]

hi

open all of the devices and check conections , test photocells if lined up and finally program control board once again

I have rewired all the photocells and keypads to suit the diagram shown in the manual exactly the same - programmed the kit from start several times - what I don't get is that it all works fine then occasionly it just shuts down - this morning they open and closed fine -i drove out then they tried shutting - then trapped the leaf together as they closed wrong

[Automatic-TC]

its looks like some problem with mainboard
do you have there any extra signal wire from home to use as push button for opening ?