Electric Gates, Garage Door, Access Control, Smart Home & Security Forums › Gate Automation and Installation Help › Liftmaster Gate Openers v
edge light

Thread Rating:
  • 377 Vote(s) - 2.89 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
edge light
tef Offline
Junior Member
**
Posts: 6
Threads: 4
Joined: Jul 2009
Reputation: 0
#1
04-08-2009, 09:58 PM
should the edge light be lit if nothing is connected, does the 8ohm resistor not stop this from lighting up. what led should be lit if only using 1 set of photocells on open/close
Find
Reply
easygates Offline
EasyGates Staff
*******
Posts: 138
Threads: 39
Joined: Jul 2008
Reputation: 0
#2
12-01-2010, 03:37 PM
tef Wrote:should the edge light be lit if nothing is connected, does the 8ohm resistor not stop this from lighting up. what led should be lit if only using 1 set of photocells on open/close

The 8.2K resistor should be connected, You should have the open/close light off, Open flashing and close flashing. Edge should be off. Make sure you have put the learn fail safe photocells jumper on, reset the board, and removed the jumper to learn the photocell configuration.
Gate Automation and Access Control from EasyGates Retail Store

EasyGates Trade Store for Trade only

Smart Home Tech from The Smart and Secure Centre

Smart Home News from Smart Home Matters
Website Find
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  LYN300 Diagnostic light flashing 6 times jeff 3 17,322 02-12-2011, 12:24 PM
Last Post: Mark
  green stop light flashing 3 18,281 12-01-2010, 03:39 PM
Last Post: easygates
  LYN400 flashing light, max watts? andy brookes 2 13,590 13-08-2008, 07:04 PM
Last Post: andy brookes

Forum Jump:


Users browsing this thread: 1 Guest(s)