13-09-2016, 09:21 PM
Hello everyone.
I have just completed the installation of a set of twin driveway gate actuators that has been in the planning and design stage for 6 months! (never been one to rush a good thing). They are BFT ORO actuators. They work well but I am puzzled by the instructions as they say that the bleed screws must be removed before electrical actuation . When I did that, oil comes out of the bleed holes, so I put them back in and have been using them like that for a couple of days. Will any damage be done by
doing that?
I would appreciate any comments about this.
Thanks
I have just completed the installation of a set of twin driveway gate actuators that has been in the planning and design stage for 6 months! (never been one to rush a good thing). They are BFT ORO actuators. They work well but I am puzzled by the instructions as they say that the bleed screws must be removed before electrical actuation . When I did that, oil comes out of the bleed holes, so I put them back in and have been using them like that for a couple of days. Will any damage be done by
doing that?
I would appreciate any comments about this.
Thanks