15-06-2016, 01:34 PM
I've installed the Came frog series gates and they won't open.
I've no wire connected to the controller pcb only shorted pins 1->2 and 2->C1
and then I briefly short pin 2 to pin 3 to try and open the gates. The relays start clicking but the gates don't move. The gates close properly by shorting pins 2->4. I have swapped the motor wiring and shorted 2->4 and the gates open so this looks like a pcb issue. Has anyone else seen this? Any ideas how to debug the issue?
I've no wire connected to the controller pcb only shorted pins 1->2 and 2->C1
and then I briefly short pin 2 to pin 3 to try and open the gates. The relays start clicking but the gates don't move. The gates close properly by shorting pins 2->4. I have swapped the motor wiring and shorted 2->4 and the gates open so this looks like a pcb issue. Has anyone else seen this? Any ideas how to debug the issue?