+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Gate Automation and Installation Help (https://www.gateguide.co.uk/forumdisplay.php?fid=1)
+--- Forum: Nice Gate Openers (https://www.gateguide.co.uk/forumdisplay.php?fid=22)
+--- Thread: NICE MC800 Factory Reset (/showthread.php?tid=7136)
NICE MC800 Factory Reset - bg148 - 08-10-2023
Hi,
Anyone know is there a factory reset ability on the MC800 ?
The manual has instructions to reset memory settings to default by pressing the start and stop buttons simultaneously but this is not doing anything.
When I power up my MC800 I get the BlueBus flashing green but every 4 seconds approximately it also flashes red. Also L1 to L8 are all flashing red.
The motor leds M1 and M2 are both flashing green.
I disconnected the two grey block connectors leaving just the motors connected to the unit but that makes no difference, still all the flashing leds!
Anyone seen similar behavior?
Cheers
bg
RE: NICE MC800 Factory Reset - Michael - 09-10-2023
Hi,
A BLUEBUS flashing light 4X indicates, there is an intervention of the STOP input. Do you have anything wired into the STOP input like safety edges?
To do a complete reset you must press and hold down OPEN and CLOSE simultaneously for around 5-10 seconds. However, this will not rectify your issue, if it is a safety issue.
Regards
Easygates Ltd
RE: NICE MC800 Factory Reset - bg148 - 09-10-2023
Hi,
When I disconnect everything and just have the motors connected to the unit I still have the same issue!
Regards
Brendan
RE: NICE MC800 Factory Reset - Matt Turner - 10-10-2023
(09-10-2023, 11:00 AM)bg148 Wrote: Hi,
When I disconnect everything and just have the motors connected to the unit I still have the same issue!
Regards
Brendan
Hi Brendan,
now you only have the motors connected you can perform a factory reset by holding down Open & Close simultaneously for around 5/10 seconds.
everything will flash and go out when the reset is complete.
then do a Blue Bus search and a position search with just the Motors connected.
Kind Regards
Matt
RE: NICE MC800 Factory Reset - bg148 - 10-10-2023
Unfortunately no joy, everything disconnected, and no reaction from the unit on the reset.
Regards
Brendan
RE: NICE MC800 Factory Reset - JoeF - 12-10-2023
(10-10-2023, 09:00 PM)bg148 Wrote: Unfortunately no joy, everything disconnected, and no reaction from the unit on the reset.
Regards
Brendan
Hi Brendan,
is there any chance you could give me a call on 01384569942 opt 2 please?
Joe