+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Gate Automation and Installation Help (https://www.gateguide.co.uk/forumdisplay.php?fid=1)
+--- Forum: FAAC Gate Openers (https://www.gateguide.co.uk/forumdisplay.php?fid=31)
+--- Thread: Gate continues trying to open (/showthread.php?tid=7005)
Gate continues trying to open - tjtj6554 - 04-09-2022
Hello All--
New faac 402 with 455 d control board: Gate continues trying to open more after stopping and reaching approximately 90 degrees.
For about 20 seconds it will make loud humming sound, like it is trying to open. After the 20 seconds it will go into the pause mode and subsequently close. Why is the arm doing this? The 455 d manual does not seem to address. Appreciate any assistance.
Thank you,
Kevin
RE: Gate continues trying to open - SamA - 20-09-2022
(04-09-2022, 05:59 PM)tjtj6554 Wrote: Hello All--
New faac 402 with 455 d control board: Gate continues trying to open more after stopping and reaching approximately 90 degrees.
For about 20 seconds it will make loud humming sound, like it is trying to open. After the 20 seconds it will go into the pause mode and subsequently close. Why is the arm doing this? The 455 d manual does not seem to address. Appreciate any assistance.
Thank you,
Kevin
Good Morning,
It sounds like the board hasn't learnt its limits or lost its memory and is over running. If you go into the first level of parameters and select time learning this will relearn the limits.
Page 17 section 5.1 for reference.
https://manuals.easygates.co.uk/PDF/misc/455-D.pdf