+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Gate Automation and Installation Help (https://www.gateguide.co.uk/forumdisplay.php?fid=1)
+--- Forum: Automatic Gates - Help and Support (https://www.gateguide.co.uk/forumdisplay.php?fid=20)
+--- Thread: Roger Receiver programming (/showthread.php?tid=4845)
Roger Receiver programming - Newuser - 12-03-2013
Hi
On my receiver circuit I see component marked Roger R70/2AC.
I cannot easily identify the programming buttons.
There is a small board at right angles to the main circuit but because of bushes it is difficult to see if the buttons are located on that board.
What size are they likely to be?
Best regards
RE: Roger Receiver programming - supermeske - 18-03-2013
hi there! On Roger Receiver there are two buttons size about 15X15 mm above LED.
There are several models of Roger receiver so you must know the right procedure for programing.
Unfortunately , I don't remember the procedure for this model... hope this will help you..