+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Gate Automation and Installation Help (https://www.gateguide.co.uk/forumdisplay.php?fid=1)
+--- Forum: Automatic Gates - Help and Support (https://www.gateguide.co.uk/forumdisplay.php?fid=20)
+--- Thread: Beninca R1.6e gate opener (/showthread.php?tid=155)
Beninca R1.6e gate opener - andylad303 - 27-03-2010
Can someone please help me,
I have recently bought the Beninca R1.6E . I also bought 2 FTC’s and an antenna with 2 remote controls. Firstly, is all this adequate for a basic operation of a sliding gate. Secondly I am having trouble with the wiring of the FTC’s. 1 of the FTC’s has 2 connections(+-) and the other has 5 connections (+- COM NO NC) ,could you tell me which number on the pcb these go to please, I have looked at the drawing but it doesn’t state clearly which number they go to. The antenna is shown going to 21 & 22 on the pcb . How are these connected, is there a special connector to attach to the outer wire of the aerial cable going to no.22 is it just twisted until it goes into the connector, I have attached the pcb diagram,thankyou, Andylad
RE: Beninca R1.6e gate opener - sebabastek - 30-03-2010
You must connect COM with 12 and NC with 14. If you have got 24Vac photocells connect + to 9 and - to 8
For antenna you do not need any special connector. Core to 21, shield to 22.
Cheers