Thread Rating:
  • 2 Vote(s) - 1.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
water damage to FAAC photocell
#4
It worked, I installed the new photocell but notice the Rx end has one light only, so went back and opened the photocell and found the two of the four cables rubber casing were damaged with wires broken 10 cm from the end inside the metal post.  Luckily there was plenty of cable length, so  cut off the damaged section and connected fresh end of cables and all is good.  Thank you JoeF! Smile
Reply


Messages In This Thread
water damage to FAAC photocell - by Rajab - 11-07-2022, 04:21 PM
RE: water damage to FAAC photocell - by JoeF - 12-07-2022, 11:38 AM
RE: water damage to FAAC photocell - by Rajab - 12-07-2022, 01:39 PM
RE: water damage to FAAC photocell - by Rajab - 17-07-2022, 08:15 PM
RE: water damage to FAAC photocell - by Michael - 18-07-2022, 09:00 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Faac 452 pcb board benner91 2 1,924 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 1,182 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  Photocell Problem marcoos_1 4 19,531 04-01-2024, 10:23 AM
Last Post: JoeF
  FAAC E124 fault 05 allan@amtas.com.au 0 794 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 4,348 03-07-2023, 08:54 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 1,291 23-06-2023, 03:19 PM
Last Post: Alpin
  FAAC Photocells mmc1977 3 2,498 02-05-2023, 12:37 PM
Last Post: Matt Turner
  Proteco gates with photocell problem. Shane1 0 2,216 09-10-2021, 07:56 PM
Last Post: Shane1
  455d FAAC FUSE IN CONTROL PANEL wildfig 0 2,157 04-10-2021, 02:34 PM
Last Post: wildfig
  FAAC foundation plate mun31 1 5,083 30-06-2021, 09:33 AM
Last Post: JamieF

Forum Jump:


Users browsing this thread: 1 Guest(s)