Problem Setting Limits on CB24 (SCS300-24)

[Guest]

Can anyone help.
I cannot move to the next stage when setting the limits.
CB 24 circuit board.
I have set the open limit and then the close limit and saved it but the light just switches between the two limits and will not go out.
I have tried both sequences open 1, open 2, close 1, close 2 as per the manual and open 1, open 2, close 2, close 1, as per the tech support advise but I cannot move to the next stage to operate both gates with the remote or push button to set the power.
thanks
Andy.

[DQuinn]

I'm having the exact same problem. Has anyone a solution please?

DQuinn

[Mark]

I'm having the exact same problem. Has anyone a solution please?

DQuinn

This results because the arm is not moving for at least 60% of it travel.

You need to use at least 60% of the motors travel so that they can recognise the limits

[DQuinn]

Thanks, Problem solved.